All pneumatic machines and tools are powered by compressed air. These compressed air comes out from compressor and through pipe lines it goes to various manufacturing units. This compressed air is further distributed to pneumatic machines and tools through pipe lines.
Generally following pneumatic systems and equipments are used in manufacturing units :
Pneumatic ball vibrator
Pneumatic die grinders
Pneumatic pressure booster
Pneumatic double diaphragm pumps
Pneumatic air hammer
Chipping hammers
Pneumatic fittings
Pneumatic drifter
Pneumatic machines
Pneumatic hanger
Pneumatic reversible drill
Pneumatic press
Pneumatic trainer
pneumatic stapler
Pneumatic shaft
Sand rammers
Pneumatic rotary actuator
Pneumatic air cylinders
Pneumatic chisels
Pneumatic nut tool
Pneumatic drifter
Pneumatic connector
Pneumatic ratchets
Mercury pneumatics
A major problem in compressed air systems is the presence of water, dust particles, oil (oils particles are introduced by lubricated air compressors) and solid contaminants which can adversely affect air quality.
If the contaminated compressed air will be used through pneumatic tools and machines then there will be following effects :
Malfunctioning of pneumatic tools / systems / machines
Sluggish and inconsistent operation of valves and cylinder
Corrosion in pneumatic systems and components
Increase in maintenance cost of pneumatic machines / tools / controls.
The Delair Solution
Remove water, dust particles, oil (oil particles are introduced by lubricated air compressors) and solid contaminants from compressed air.
Delair offers wide range of refrigeration dryer and adsorption dryers which removed water / moisture from compressed air.
Delair refrigeration dryers operate on the method of cooling the air to near freezing point to remove the moisture and reheating it to approximately 10°C below the incoming compressed air temperature at nominal conditions.
Delair Adsorption dryer
The dryers is based on the principle of heatless regeneration and the physical properties of ther desiccant to adsorb and desorb the water vapour, It uses pressure swing principle / purge air to regenerate the desiccant bed.
Filters
Delair also offers Pre Filters and Oil Filters which removes dust particles, oil particles and other types of solid contaminated present in dry air.